Abstract: This Technical Note addresses the considerations and recommendations for the design, detailing, material selection and construction of brick veneer/steel stud walls. This information pertains to behavior of the veneer and steel studs, differential movement, anchors, air space, detailing, selection of materials and construction techniques.
Detailing Series - International Masonry Institute
This compilation includes hundreds of details for brick, block, and stone masonry systems, as well as details for ceramic tile, marble, terrazzo, plaster, rainscreen systems, terra cotta, AAC, and masonry restoration.
16 Brick Cladding Constructive Details - ArchDaily
2019年6月26日 · Brick cladding, also called "Face Bricks", can be specified in a large number of colors and textures, and in their summation and variation –thanks to their different shapes and sizes– they can...
Base of Wall Detail - Anchored Brick Veneer
This detail illustrates a base of wall condition with a partially grouted and reinforced concrete masonry foundation. Below grade waterproofing and an air/moisture/vapor barrier above grade provide continuous resistance to air and moisture; continuous insulation offers …
Satisfactory performance of brick veneer/wood stud walls is achieved with the following: (1) an adequate foundation; (2) a sufficiently strong, rigid, well-braced backing system; (3) proper attachment of the veneer to the backing system; (4) proper detailing; (5) the use of proper materials; (6) good workmanship in construction; and (7) proper m...
Technical details - Midland Brick
The information and technical details provided correlate with all legislative requirements and generally accepted good trade practice. Although provided as a guide only, common sense and job specific detailing can be added by qualified designers.
Abstract: This Technical Note presents information on adding anchored brick veneer and thin brick adhered veneer to existing construction. Considerations and recommendations for design, detailing, material selection and construction specific
steel studs, the veneer is classified as brick masonry veneer with a steel stud backing, (BV/SS). Figure 1.1 shows a typical brick veneer on steel stud installation. Normally, the ties of the veneer are flexible for in-plane horizontal and vertical move-ment and rigid perpendicular to the wall face. Thus, the veneer and the backing are
veneer shall be installed a minimum of 4 inches (102 mm) above the earth, or a minimum of 2 inches (51 mm) above paved areas, or a minimum of ½ inch (12 mm) above exterior walking surfaces which are supported by the same foundation that supports the exterior wall.
Detail 01.030.0332 Rev. 05/02/19 | Anchored Brick Veneer, CMU Backing, CMU Foundation KEY WORDS Base of wall, Foundation, Veneer, Brick, Flashing, Drainage, Weeps, High-performing, 01.030.0332, Thermally-efficient, Anchored veneer KEY NOTES Brick veneer 01 Concrete masonry backup Horizontal joint reinf. w/ eye & pintle veneer anchors 02 31